The printer automatically recognizes that the duplex option has been installed. If you purchased an Optra S 2455 or optional drawers, you received a sheet of decals. Then, pull the paper straight out. This is true even if you advise Lexmark or a Remarketer of the possibility of such dam- ages. When it is full, the printer starts filling the first output option.
See 61 Defective Disk on page 189 for more information. Start with features and options that are installed below the printer. Your problem is solved now Thank you! The voltage at J3-7 measures approximately +24 V dc. After that remove the control panel by undoing the four screws holding it in place. Getting Started Clips Setting Up Your Printer. Memory Connector 1 Memory Connector 2. As funções de segurança de alguns dos componentes podem não ser sempre óbvias.
Trays for support units installed under the printer are numbered Tray 2 down to Tray 5 depending on the number of optional drawers installed. Be sure the edges of the printer and the support unit are aligned so that all the parts fit. The Not Ready message is displayed. The door hinges fit into the notches. If the card is installed in connector 3 on the printer system board, the functions for that card are displayed as a value in the Network Option 3 menu.
The following illustration shows the Optra S 2455. Disconnect any cables attached to the printer. Clearing Jams Pull the paper straight up and out. Pressure sensitive area must enter the printer first. The printer prints a new copy of the page that jammed if Jam Recovery is set to On or Auto; however, the Auto setting does not guarantee the page will print. Check the continuity of the cables connected to J3 and J8 on the engine board.
The tissue will come out covered in ink. With Duplex set to Off, the printer prints only on one side of the paper. Locate the overlay packaged with your printer. Pull the metal bar straight out to extend the multipurpose feeder to its full-length position to hold longer paper. The printer fills the Standard Bin first. Be careful not to scratch or leave fingerprints on the print sides. If incorrect, replace the engine board.
Look under the rear door for the edge of the paper. The printer is ready to receive and process data. Multiple Parallel 1284-C Adapter cards can be installed and used on models with multiple connectors. To help prevent this, do not load paper that is smaller than the page size of the job to be printed. Note: If you have purchased any other options, install them now.
If incorrect, replace the engine board. Be sure the edges of the printer and the support unit are aligned so all the parts fit. These labels are supplied in letter-size and A4-size sheets. Stack Height Limiter Load one type of print material in the multipurpose feeder. Solving Printer Problems Action Make sure the packaging material is removed from the print cartridge.
The voltage at J3-7 measures approximately +24 V dc. The 260 Paper Jam is shown here for a jam in the optional envelope feeder for the Optra S 2455. Caring for Your Printer Latch Bar Duplex Front Access Cover Clearing Jams. Be sure the edges of the duplex option are aligned with the drawer underneath so that all the parts fit. Characters have jagged or uneven edges. Turning the Printer Power On Turn the printer power On. Delenes sikkerhedsfunktioner kan være skjulte.